... Question: I'm trying to change out my tail light assembly on my 87 ch250. I know it's held in place by three bolts, the two above the license plate bolts...
update on my carb problem.... i re-installed the carb, using hose clamps to make sure that the vaccuum lines were tight and i also made sure that the tab was...
update on my carb problem.... i re-installed the carb, using hose clamps to make sure that the vaccuum lines were tight and i also made sure that the tab was...
Sorry, I searched on the item number in the OP mail - and that says it was sold, "buy it now". I found it listed again, like you said, as 320337030638. It's...
Hi All, Just to let you all know that I just got the Spacy starter motor problem fixed. Just to remind you all. The Spacy would not start after filling her up...
I am trying to take the plastic cover off of a 86 speedometer cover . I think the trip button has to come off , does any one know how to remove it ? Thanks in...
the trip button does need to come off to remove the bezel.  the button is a press fit, so you need to be extremely careful. i've done it by putting 4...
... i've done it by putting 4 fingers on it (index + ring from each hand), then pulling all 4 fingers up at the same time. ... dryer. ... cover . ... So the...
... Yes, the button top, the stem and the little rubber apron that might still be there should all come off, leaving a brass colored pin sticking up to just...
... careful. ... hair ... how to ... might ... That worked , it came right off with a little more than a little bit of pressure . I got it all cleaned up but...
" Â but I would like to roll the miles back to zero , before I put it back together . Any ideas on you roll these back ? TheReaper! I think you have to turn...
... back on its own or try putting it in reverse and driving it backwards!! ... topic ... Foods ... Switch format to Traditional ... Never mind , I got it ....
Hello - after purchasing an '85 this summer (see the Green Machine in the Photos section) and riding it about 1000 miles I decided to remove all the plastic...
... each ... a ... speedometer ... TheReaper! ... That's ... the ... bit ... Well I got zeroed out , but I still have one problem with it . One of the screws...
... If it's still apart, you might want to put a little light oil or even mineral oil on the many places where the mileage meter rotates and also into the...
... It's to late , I already put it back together and packed it away . If and when I use it I'll oil it up . I've got about a dozen big boxes of parts now for...
I just replaced mine. I had to remove the rear bumper, and use a 10mm socket and extension to remove the inside bolts that hold the rear body panel in place...
Being the typically lazy (and absent-minded) American, I'd like to have this feature on my scoot too. Where would I be able to get the unit and could it be...
Wouldn't hurt to spray some WD40 into the switch. It's also possible that the brakelight switch (which also enables the starter to work when you step on the...
the install is easy because the mounting bracket is already welded to the downtube. well, easy that is once you have all the plastic out of the way!  i'm...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
