Hi everyone! i just got my MEK & Prophet 08 desktop two days ago. i heard that the "mostly analog" bank for the evolver is really good. i want to upload it to...
Hi, I use my computer sequencer (Cakewalk Sonar) to read the data dump banks from the Evolver to back everything up. If you've worked on any programs that you...
I want to record Evolver sequences in my computer sequencer (Sonar). When I MIDI synch the Evolver, the Evo sequencer turns on when I hit play or record in...
Page 42 of your Evolver Manual : MIDI Clock: Selects the MIDI clock status, and enables External sequencer triggers, as follows: ******************** IN-...
Right. That's my problem. I don't have the ability to control where the sequence starts playing in my project when I have MIDI synched. I can't start/stop the...
there are no realtime(tune etc) that work with evolver right? peace.. peter ... Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now....
Hi Larry - Please check your MIDI Setup. It sounds as if the Editor isn't communicating with the Evolver. Go into MIDI Setup (under the MIDI menu). If the...
ok! realtime messages like volume, tune etc, sent from in this case a mpc, in addition to CC# that i know it responds to.. follow me? peter Robert Krueger...
Hi Bob, Sorry for the delay in getting back to you. It appears that you only have one-way MIDI communication with the Editor. Please confirm that both MIDI IN...
Hi digital_lofi, What problem are you experiencing? Recently, several users reported a similar problem with the Editor not responding to the Evolver - these ...
Thanks for getting back to me. I tried version 4.06 and I had the same problem. I have MIDI setup so that out/in are both "MIDISport 4x4 C" - At the top of the...
Are you modulating filter cutoff with the oscillators? I forget exactly what it is called but it's something like Audio Amount in the Filter section, or...
Hi I noticed this too but not just for synced sounds but for all of them. It's only really noticeable on higher pitched sounds, if the filter cutoff is very...
Hi I am having trouble sending my banks from the vyzor editor to my desktop evolver. Can someone remind me - do I need to set the evolver to some special mode...
Make sure that the Evolver has MIDI SysEx send and receive enabled. Other then that, check your MIDI cables so that IN/OUT is connected to OUT/IN on your...
I cannot for the life of me figure out how to control the evolvers midi clock or make it control a midi clock. When the midi clock is set to "in-" and I hit...
Thanks for the info in this thread... I have a similar problem. My MEK outs are routed into my PER mix input, and like everyone has said in here... Ever 5...
Hi, I have an MEK, PER, and an EVO. When I chained the MEK and the PER I didn't notice a volume difference. Maybe there are some hardware manufacture...
could anyone help me with or send me a sysex table for the evolver. i cannot makes sense out of the manual codes.. what i would like to do is prgroam the...
hello. i can anyone help me. i would like to program my midicontroller for the stepsequencer - the steps, starting and stopping etc. - but i do notunderstand...
me to.. what midicontroller do you have? peter andreazkuit <sic-rec@...> wrote: hello. i can anyone help me. i would like to program my midicontroller ...
I just bought the Oxygen 49 and I want to try using it with my Evolver desktop. Before I try to figure out how to map the controllers to Evo values, I want to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
