Of course it's a problem of the shape of the curve, near the U ... ___________________________________ L'email della prossima generazione? Puoi averla con la...
Hi Edward, of course, please look the photo. There's some irregularities in that point, maybe is not balanced but sure is not the right facing curve ... ...
I'd like to open a tip on a mpce. For an ex. from an opening of 0.090" to 0.100" tenor. Obviously there is a limit to how much mat'l can be removed to...
... It depends on where you are starting from. If it is in the 44-48 range, I would add 2 numbers to it. If it was shorter, I might add 4, longer, keep it...
I think Keith's recennt posting may apply to this mouthpiece question: "When I gun sight along the baffle from the tip, I like to be able to see at least 1/2...
Hello listers and mouthpieces workers I'm a subscriber of this for several months now, and just spent this time reading all the very instructive posts of this...
There is no real standard for Brilhart facings that I can tell. Every one is different. Some are good, some are bad. I would recommend you take measurements...
Thanks again Keith. You've been very helpful. What a great site! ... From: Keith Bradbury To: MouthpieceWork@yahoogroups.com Sent: Saturday, March 01, 2008...
Hi, I described in a recent post the behaviour of this piece. It has a well balanced tone at lowish pressure levels but as soon as I push more air through the...
I find it important to cut material away just behind the tip rail for free-blowingness. No matter how high the baffle is generally (and it is possibly more...
Have you measured the facing curve? That should reveal whether there are any flat spots or unevenness in the curve. Regards, Andrew ... I push more air ... at...
... Hello Eric, It may be of only academic interest to know the Brilhart 3* was .045" tip and .594" length (15mm) All the * numbers were of this length, given...
... Thank you Edward. This is more than academically interresting ! At least it confirms me that the mouthpiece have been (very badly) refaced. Eric -- ...
Hello all, I've been a member for a while and have been reading the helpful posts that you all provide and trying to learn as much as possible. However, I'm...
This month, Mikole is performing at the Dixieland festival here with the Geno Antonacci group. They will have a segment that is a tribute to Benny Goodman...
Keith, Thank you for your reply. To answer your questions: Yes. I've gotten the morgan set. I have measured facing curves and read a lot of the material...
I recently bought this Mpce. I also bought a 50's Conn Nkd Lady bari in great shape. I've been messing with Bari's for the last few years. I want to keep this...
... Get a simple ruler with a mm scale and hold it next to your glass gage. Try to figure out if the scale is in direct mm, or 1/2 mm per line division. Watch...
Thanks Keith. The scale of the glass gage, relative to the numbers stencilled on the gage, are 1/2 mm's. The actual lines are 1mm apart. I goofed with the...
Part of the response problem with the Rico mouthpieces is the way the baffle is concave right after the tip. This was a result of the facing being molded on,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
