I heard that Polysix can be used as effect processor. Has anyone done this mod? I know that there are some inputs and outputs on circuit board, but don't want...
hello, I have a big problem with my polysix. everything is fine, but when I turn it on, after a minute or two the filter makes some strange modulations.....
Having repaired several dozen of these, I would say that visual inspection of the traces is not sufficient; there can be damaged traces under the ICs, and...
This seems to be a popular topic, but once again: I Can't get the F***R to "tune". Ive done and redone the procedures in the Service manual, but it still only...
The tuning procedure in the service manual is written from a technical point of view, which is OK because it was made by engineers for a piece of electronics...
Thanks Johannes. I have changed the PC-1 unit, as well as looked at all the outputs from it and all the other pots as well, and they seem to be within...
I've borrowed an oscilloscope from an friend, and thought I'd give the Polsix a good going over, but alas, I've failed. When it says connect the scope to...
Hi Folks!,i am in need of the above tested and working if possible.mine has had the usual battery leak and iv never seen one so bad as it has obliterated the...
ok, I checked the klm361 (digital pcb) all traces and thru-holes in the battery section are ok... I measured them with my multimeter. I made a sound example so...
Did you check the continuity of the board connectors? I've seen corrosion inside the connectors. Just do a simple continuity check from the board on one side...
thanks, I'll try that, but I think it's not a connector problem, when I switch the polysix on, everything is fine for a few minutes, then these strange...
Hi i am trying to source out a replacement for PC1 on the KLM-366 board but having no luck as yet.does anyone know where i can get them from or an easier to...
I checked all the connectors, changed 2 ics near the battery and it became much better. when i turn on the unit the first 20-30 minutes everything works fine, ...
It's just about always a good idea to replace any and all electrolytic capacitors, as they do dry out with age. Having good beefy new capacitors in the power...
the best way to track down heat sensitive parts is to use something like this: http://www.crcind.com.au/catalogue.nsf/web_brands/Freeze+Spray? openDocument be...
Hello, I picked up a polysix today. Ordered it from the states (living in Ireland). However when I turn it on, all the lights come on (literally all the ...
the easiest fault could be the tape section. Mayby the last owner saved his works and enabled the tape section. Switch them to "disabled" and try again. Yours...
Yeah, I thought it was the tape section. Tried disabling it but that did nothing. It definitely seems like the tape enable is "stuck" on. The output of the...
Check Section 8 of the SERVICE manual. You can download it here: http://www.chromatest.net/POLY6_Service_Ensemble.pdf It's also linked from this group's...
I had the same behaviour happening on a Korg Trident MKII I found and repaired. If I'm not wrong it only takes to readjust a single trimpot on the controller...
If I remember correctly, the PSU should be easy to rebuild. I don't think there is anything special about it. IF you can't source a purchase, maybe consider...
... Hi, I have a broken on from which I can make a working one.... Would that be ok ? Alternatively, I'd be glad to buy your KLM367A in case you won't find ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
