I found that I could not load the latest firmware from the USB
connection. I had to do it via MIDI.

--- In bc2000@yahoogroups.com, "yanayayafr" <mailing_list@d...>
wrote:
> Hi,
>
> I just received a BCR2000 yesterday afternoon from Digital
Village.
> Plugged it in, turned it on and installed the drivers from the
> Behringer website (Windows XP Pro), seemed to work fine.
>
> The power on version showed 1.03 so I decided to upgrade to the
> latest OS version before continuing. Using MidiOX I sent the
> bcr2000_1-04.syx file to the device as per instructions on the
> website. There were a couple of errors shown on the device's
> display, and it finished with the message "boot". I turned the
> BCR2000 off and then on, only to be greeted by "noOS" displayed
and
> the STORE and LEARN buttons lit. The BCR2000 didn't respond
> to anything.
>
> The solution is to power on the device while holding down the
STORE
> and LEARN buttons. The display should now read LOAD. You then need
> to plug a MIDI cable OUT from the PC, to IN on the BCR2000, and
send
> the sysex upgrade to the BCR2000 through this. This worked for me
> and now I have a perfectly functioning BCR2000 again.
>
> I hope this helps someone!