I have a Korg Mono/Poly MP-4. I was able to tune each Osc on Circuit board KLM-398. However, as you ascend the keyboard up from the lowest note to highest...
Hello. I am new to the group and a new proud owner of a Mono/Poly. I see there hasn't been any activity in the "patches" section for a few years. Does...
Hi ... Check the CV at the CV-Out; if this does not read V/Octave, then adjust VR2 on the processor board (KLM-356). If this reads correct V/Oct it would...
yeah seems you are right. i posted some of my own a few years back but it seems no amount of encouragment could get others to do the same. :( ... I see there...
well once again to do so please download the patch sheet from the files section. fill it out then scan it back into your computer. please upload it to the...
Hi, My name is Nick, from Australia and I have owned a Mono/Poly for about one week! Up until yesterday, it worked 100% but I fear it's dying now... Triangles...
Hi The higher the Resonance the lower the level of the signal. This explains why the distortion is gone. May be you simply switched the output level to "high"...
Hi Florian, Thanks for the reply! I don't think that's it, as there is no change in this even with headphones directly plugged into the Korg. I have also...
Have you checked that the Arppeggiator isn't set to latch. with MG2 at a high speed this can make thigs sound like you discribed. I often have moments when its...
Wasn't sure if it might be the wave form symmetry. had a quick look through the service manual but couldn't find any thing on adjusting this. another cause...
Hello Nick, I am sorry to tell you this, but this does not sound good. To me it sounds like a broken filter chip. Appearently the filter dose nto work as it...
"Does the filter basically work? What happens if you turn the cutoff frequency potentiometer full counter clockwise?" - Florian Yes, it does work, but seems to...
Enter your vote today! A new poll has been created for the korg_mono-poly group: What Korg Mono/Poly patch do you think should be the winner of the 2008 patch...
korg_mono-poly@yahoog...
May 18, 2008 9:17 pm
312
hello my fellow mono/poly users! i am holding a patch contest for 2008. if you wish to enter please upload your file to the 2008 patch contest folder. i...
The chip is firmly in it's bracket, so I guess it just died with the excitement of being used again after 14 years. :-) I owe you guys a lot, because I was...
Hay chaps. Anyone know of a good place/site where I can source monopoly or polysix knobs, buttons etc. I'm keeping an eye on ebay but finding a good suppler...
Looking for any colour push LED button but preference yellow or white. and a gray knob cap. Don't need the potentiometer its self. But to be honest if you have...
Hello people. I've been busy under the hood so to speak and have come up with a mod to use VCO 12 as a modulation mixable to the MG1 controls. Also with a...
I got excited a few years ago and modded my Mono/Poly. Now all bets are off : ) That's a great mod. I was poking around with stuff like that, but didn't think...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
