heya guys! some time ago i opened my mono/poly to tune the 4 oscilators so that when all the tune kobs face zero, it would play everything in tune. well after...
Hi Michael I wrote down the way, I am tuning the MonoPoly VCOs, and put it to my website. See http://fa.utfs.org/diy/korg_monopoly/vco_adjustment.html The...
Hi everybody! I need to replace the MG1 knob, do you know which potentiometer I should get? Also, is there something I should be extra careful about when...
Hello Sophie ... Do you need to replace the knob (the plastic thing, which sticks on the the potentiometer) or the potentiometer itself? If it is the ...
Alternatively you could try the seller "Organ parts" http://myworld.ebay.co.uk/organparts&ssPageName=STRK:MEFSX:SELLERIDon ebay he often has the correct...
Great news Sophie. Heres to many more years of happy mono/poly modulation. ... From: lakaband_in_uk <sophiebernhard@...> Subject: [korg_mono-poly]...
Hi, I have a problem with mono/poly arpeggiator and I hope that someone could give me a hint what could be wrong. When I set arpeggiator in latch mode and...
Hello Tero ... Some questions for analysis: Do the four VCOs play all the same note, or the notes you pressed as arpeggio chord? Does this happen with external...
Hi Florian, I have to double check the notes that are played by the VCO's when I'm back at home. Meanwhile I can answer to the other questions... The result is...
Hi Tero ... It is difficult to judge this without knowing details about the modifcation. In fact the behaviour you are describing is like there would be a ...
Hi, I tested the arpeggiator again and to me it seems that VCO's do play different notes. I opened the mono/poly to check where the CV modification is...
Hi, It seems that light fixed the arpeggiator because it's working normally now after I assembled mono/poly back together. It might be some contact failure but...
... Hi Florian, thanks for the welcome. I've had my mono/poly for about a week now and am very impressed with it. I'm not sure I completely understand...
Hello everyone! I still am a proud owner of the mono/poly but I have so many problems with it! First, I bought from ebay and it arrived broken: the case and,...
Hello,  I have heard decent things about synth restore and they are based in the uk. www.synthrestore.com  And custom synth also does amazing work on the...
Hello and welcome to the maillist! ... As I am a kind of collector of Roland Synths I can tell you, that the Korg MonoPoly is very good complement for the...
Have just switched everything on for a rainy afternoons knob twiddling to find mono-poly is dead. I suspect/hope fault is an internal fuse (in power supply?-UK...
Hello ... There are two fuses with 1.6 Ampere slow blow each on the low voltage side of the transformer. They are located at the power supply pcb, which is...
Removed the four screws on front panel..but panel is loose but still fixed at rear when i try levering it upwards? Are there any other fixings on rear of panel...
yes there are three screws along the rear underside. once inside you will see fuses on a board fixed to the bottom of the case and then another set of fuses...
Many thanks to Florian and Alan -Mono-poly is working again. I just replaced the two 1A fuses (they were not rated 1.6A as Florian mentioned -so maybe this i...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
