Thx for answer!

When i programm the pic and then read out the statusword the intern oscilator is
activatet. Whenn i try to set the config to XT (extern oscillator) then the mc2
dont make anything. No Startup sequence.
When i set the config to intern osc the Startupsequence is working but no
mididata recived the pic(or the pic dont react to this).

I think there is something wrong. Because normaly whenn i programm the pic with
the hex the OSC must set to extern. But it isnt.
The quarz is a 20mhz and the capacitators are close to the quarz.

So i think my problem is in the programming.
Whenn i am use the intern osc all works fine except the pic dont start whenn
midi arrives. When i try to use the extern osc nothing works. i Dont know whats
going on.

Mybe i try to find a preburned pic to look if the problem is on the programming
side.




--- In lsdjmc2@yahoogroups.com, firestARTer <firestarter@...> wrote:
>
> The config word is included in the hex.
> Never activate copy protection, as then you can't successfully reprogram
> the pic again, as far as i remember.
> Set it to HS oscillator and don't program in LVP mode, then it should be
> fine for the soft.
>
>
> On 3/29/09 3:50 PM, markus770807 wrote:
> >
> > Hello, i am new in the list and i have a few questions.
> >
> > I have a vm111 pic programmer and this one allows only to set the
> > config of the pic with a configword in hex. I looked in the datasheed
> > and found some infos.
> >
> > I try different configwords but nothing works.
> >
> > Has anybody the config word in hex for the pic?
> >
> > Please please help!!!
> >
> >
>