Hi, I'm new to the group but have been around MIDI for a long time. I have several pieces of Roland equipment and I'm in the middle of a project of getting...
Is anyone using a Godin LGXT that can recommend the best MIDI converter? I'm using my old Yamaha G-50, which does an OK job, but there may be better, as the...
Hi all, Picking up on this topic again, I have done some experimentation and a lot of research and found out the following: 1) Muse Receptor is expensive, but...
... Everyone: I'm guessing David's sequencer is receiving conflicting pitch-bend messages from his GI-20 *and* something else in the chain. Do you think that...
Hi, Marcelo One solution to setting up your soft synths in multimode is to use something like Brainspawn Forte http://www.brainspawn.com/. This should allow...
If you are triggering an external sound module or soft synth, then one of the current Axon units should be your best bet. This is assuming that you are...
This sounds as though the bend range setting no longer matches correctly when you've loaded a sequence. I've had the same kind of problem with software...
This may sound silly but it really is relevant, when did you last change your strings ? BTW the bend range on whatever you're using for playing back the ...
I have had good luck with both the Axon and Roland GI-20. have the LL Baggs in mine and wish i had RNC. It of course does nice with VG products as well. Dave ...
dave@...
Jul 8, 2008 10:06 am
26757
I been having problems adjusting different parameters on my Axon 66 and can't find my manual. I was curious if anyone knew of where to find a online manual so...
Moonie, I'll try using Poly mode but if I remember correctly, I think I tried that once and it didn't make an appreciable difference. However, I could be wrong...
Thanks for the tip Rich. I'll check that out as well as the suggestion Moonie gave. -David ... correctly when you've loaded a sequence. ... automatically reset...
Basil, Thanks for the response but the strings on both guitars are brand new and I got the same result with both instruments. And yes, I made sure the hardware...
Did you try starting a new song from scratch to check if you have the same problem. If you sequencer is somehow recording midi CC data, it can really load it...
... I think that's the mode you're using now, so ... use the other one. I think you get the idea. On my GR-33, it's called "Mono mode", which can be confusing,...
Righto, ANY guitar synth (or any synth used with a midi guitar interface) simply must be capable of playing in Mono Mode... in Poly mode all PB data is applied...
David Messenger
mssngr@...
Jul 10, 2008 3:55 am
26765
Its (IIRC) due to Yamaha getting Poly and Mono mode confused on the DX7 which became the de facto standard and caused all the difficulty in understanding...
... Yes, Craig wrote about that, oh, twenty years ago, but it's not like you can easily find that, or encounter it often, if you're young, or if you're new to...
Thought I'd run this by the list before putting it on eBay. Very good condition with original hard case. Tracks well with a Roland GR-20. Nice jazz tone...
Flatwounds ?? yes!! and i thought i was the only one useing flats. All my freinds look at me like i'm out of my mind. LOL kind regards jd ... From: "Paul"...
Hi darkstr1746 On 11/07/2008 you wrote; dcn> Flatwounds ?? yes!! and i thought i was the only one dcn> useing flats. All my freinds look at me dcn> like i'm...
Hi Graeme, JD, and all, ... That is true, especially with Roland equipment. With flats, you always have less glitches. With the Axon, however, it doesn't not...
Hi Marcelo On 12/07/2008 you wrote; ... m> That is true, especially with Roland equipment. With flats, you m> always have less glitches. With the Axon,...
I started out in the early sixties playing flatwounds and didn't switch to rounds until several years later. Didn't go back until the early 90's when i did a...
I should be receiving my Ramirez 2CWE with outboard Polydrive in the next few days - it feels like it's been a long wait. I'll post some initial reactions and...
Hi All, I just got back from a trip to Nashville, where I attended my 1st Chet Atkins Appreciation Society Convention. Hundreds of the best fingerstyle...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
